[LAGUN] Replacement Lever/Handle (Plastic w/Stainless steel insert)

The Lagun table leg and arm lever is a replacement part, but it’s always included in complete Lagun table stand sets. This lever allows you to lock or unlock both the arm and leg. It features a convenient lock release button that lets you adjust the lever position without affecting the table’s tightness.

• 1 Handle (Salt Air Approved)
• 1 Stainless Steel Bolt
• 1 Washer

Handle Replacement Instructions:

• Use a rag to protect the arm/leg & secure in a vice or similar device.
• Using a hacksaw or a similar tool, use slow even strokes to cut the handle or bolt
• Tap out the old bolt
• Remove end caps (if applicable)
• Install a wooden block inside the end of the leg/arm.  Make sure the block is relatively tight, so the aluminum does not get compressed.  The block should be right next to the hole the bolt is going to be re-inserted into.
  • This MUST be done so you do not cause the aluminum to become distorted, thereby ruining the function of the leg/arm.
• Install new bolt, washer and handle
  • Loctite anti-seize for stainless steel may be applied
• Remove wooden block
• Install end caps (if applicable)

CAUTION!!  The "Original Lagun" parts are NOT compatible with the knockoff systems.